No, although we support those professions we also support armed citizens and don’t play favorites.

Unfortunately we do not have control over the timing of the heat treating and coating process and cannot provide ETA on when these carriers will be back in stock. 

No, we do not allow back orders of out of stock products.  You can sign up for in-stock notifications on each product page.

Yes.  When changing the mass of the operating system, it is important to adjust the gas system accordingly.  We recommend adjustable gas on all ARs to deal with the wide variety of ammo, propellants, barrel lengths, gas port size, ect.

In stock orders usually ship in 24 – 72 hours and tracking info will be emailed once your order ships.

Unfortunately no.  The design of those folders prevents their use with any captured buffer design.

The Competition buffer is ONLY for rifles equipped with low mass carriers (either steel, titanium or aluminum) and adjustable gas blocks.  The Duty Buffer can be used with low mass or regular carriers.

No.  It was designed specifically for that system.  9mm blowback setups require much more mass to safely operate.

No. Any captured buffer should not be used with a blowback pcc.

No, however it is highly recommended to make installation and removal easier.

If your buffer is in spec then no. If your buffer does not protrude slightly from the lower when installed then add one washer and check fit. Add the second washer if it is still sub flush. 

No, we can not directly ship outside of the U.S.  We do arrange for export of wholesale orders through licensed export services.  Contact Russel@unrivaledusa.info for wholesale order inquiries.

It will with an A2 to carbine tube spacer.  JP Rifles sells a suitable spacer.

It can but will need a spacer of .750″ to take the internal length to carbine length. (can use a stack of quarters or washers)